In the driving operation of the tractor, the new driver often has a gear-shifting phenomenon, which not only gives off a harsh noise, but also greatly aggravates the wear of gears and even damages the gears. To avoid gear shifts, new drivers may wish to note the following:
The free stroke of the clutch should be kept within the specified range, and pay attention to checking and adjusting regularly.
The three separation levers of the clutch are in line with the clearance of the release bearing and meet the specified requirements.
The driven plate should remain flat. If warpage occurs, it should be repaired in time.
For a tractor equipped with a single-cylinder engine, reduce the throttle before shifting, and then shift gears until the speed is significantly reduced.
For tractors equipped with multi-cylinder engines, the two-legged clutch method should be used when shifting gears. That is to say, the throttle should be reduced first. After the vehicle speed is reduced, the clutch pedal is depressed and the shift lever is set to neutral; the clutch pedal is loosened, the throttle is increased, and the rotation speed is increased; Lower clutch pedal, shift the shift lever into low gear. At this time, the gear speeds of the top and the bottom of the passive gears are relatively close to each other, and they are easy to mesh.
Hot Air Circulation Drying Machine
Hot Air Drying Machine,Circulation Drying Machine,Air Circulation Drying Machine, Drying Machine Air Circulation
Zhucheng Tongxi Commercial And Trade Co.,Ltd. , https://www.blackgarlicgroup.com