1, silage cutting machine
(1) Usage: The user can choose different materials according to the length of the required material to adjust the gap between the movable knife and the fixed knife. During the work, the moving knife passes through the clearance of the fixed knife, and the cutting speed is fast. This is the productivity of the machine. key. When cutting relatively thick straw such as silage corn, the gap is 1 to 2 cm, and when cutting fine straw (such as cereal straw), the gap is 0.2 to 0.6 cm. After turning on the power supply, it is necessary to idle for a few minutes, and pay attention to whether the running direction is correct. After everything is normal, you can work normally.
(2) Precautions: The work site should be spacious; the electric gate should not be too far from the machine; the staff should not touch the operating site, and it is not possible to open the case and remove the safety cover; the clutch and the joystick are pulled in and pulled out. Reversed and returned. If any blockage or foreign matter is found, you should immediately push the joystick outwards to exit the material and close the switch before troubleshooting. The staff should always pay attention to picking out stones, bricks, irons and other hard objects in the material to avoid damage. machine.
2, forage, straw kneading machine
The machine can knead corn stalks, bean stalks, and other straws into soft, crumbly feeds, which are generally silky, uniform and soft, and all forage grasses can be basically eaten by cattle and sheep.
(1) How to use: When working, make the machine idly for 2 to 3 minutes. If there is no foreign matter touched by the card and an abnormal noise is generated, the machine can be put into normal production and work. The operator must stand on both sides of the material inlet, and the arm should not extend into the material inlet; the material should be evenly filled, and the multi-feed material is prone to jamming, clogging, etc., and do not use fillers such as sticks and iron rods to prevent damage to the machine. Pieces.
(2) Precautions: Immediately after the machine malfunctions, cut off the power or power supply, find out the cause, and identify the fault. If the feeding mechanism is uneven, the machine will rotate the tooth chuck. After the belt is reversed, the jammed grass will gradually be cleared by hand. Remember! Do not connect the power before the grass is clean. To ensure the safety of the operators, a protective net should be installed between the gears and the belts of the machine. The power line should be checked before each shift to prevent breakage and damage to the workers.
About 30 hours after the machine works, each drive bearing part should be filled with grease once; after 300 hours of operation, the bearings should be removed and cleaned, and new lubricant should be added. Tighten the screws and nuts of each drive section; inspect the wear of the belt; if heavy wear occurs, replace it in time to prevent breakage and injury.
With the raising of the needs for Rehabilitation Products, ORIENTMED has found its Rehabilitation Products line. The main products are Aluminum Wheelchair, Reclining Wheelchair, Electric Wheelchair, Leisure Sports, Steel Wheelchair , Commode Wheelchair , Bath Bench , Walking Stick , Rollator , Travel Walker and Hospital Bed . Those products are all get the CE, ISO, FDA.
Those products are all designed and sold by ORIENTMED. Our products is in a good quanlity and our price is competitive. Especially the hospital beds, we have sold 60,000pcs per mouch.
Welcome to ask us for quotation! Welcome to vist ORIENTMED. For health, we will do better!
Rehabilitation Products
Foldable Wheelchair,Walking Stick,Travel Walker,Hospital Bed
Hebei Orient Imp. & Exp. Co. Ltd. , https://www.orientmedcare.com